Problems still exist even after system restore to factory settings?

Question

I have a Toshiba Satellite L645D-S4040 with Windows 7.

Each time I turn my computer on it has a black screen saying theres nothing to boot up using, and to enter a boot disk. It works fine, except when I tried command prompt to fix the boot up (Bootrec /fixboot, and other options) It says something=0. I don't remember exactly what it said. So, I saved my files and did a entire system restore to factory settings. The problem booting still exists, and now if I attempt to download more than one program my computer shows me a black screen with a blue square explaining and error was found and yaddayaddayadda.

Please help~ <3 Thank you!

Answer 1

Creating system recovery media using the Toshiba Recovery Media Creator utility.

This should be done when setting it up for first use or just after doing the system restore/recovery.

https://www.csd.toshiba.com/cgi-bin/tais/support/jsp/bulletinDetail.jsp?soid=2753749&pf=true



How to restore your Toshiba laptop PC to its factory fresh software condition.

https://www.csd.toshiba.com/cgi-bin/tais/support/jsp/bulletinDetail.jsp?soid=2737864&pf=true



Order the recovery media: https://www.csd.toshiba.com/cgi-bin/tais/support/jsp/serviceUnitVerification.jsp?orderType=SFF

Answer 2

Sounds like your BIOS is set to boot from CD rather than hard drive. When you boot up again there will be a screen that says press ... key (usually delete or f4) to enter setup. Go there into setup and make sure your settings are set to boot from hard drive then save & exit and reboot. This should fix the boot problem. As for the other problem, I would try re-running your system restore (also found on the bootup screen- should say for system recovery press ....)

Answer 3

i'm unsure while you're responsive to the geared up in imaging application featuring W7? it is an exceedingly reachable device whilst your laptop can no longer carry out a device restoration. Reload domicile windows, finished all updates, set up/configure all your in demand application and do not forget approximately any added hardware that must be linked. Then do right here... click initiate(orb) and variety "Backup and restoration" click Create a device image choose your region to lower back your laptop to and click next. ** bear in mind which you will would desire to bear in mind this course in case you put in on a community force or exterior hdd. you will would desire to manualy enter the path if/once you do a restoration, so the shorter the better. additionally, you do no longer % to create the image on your community discs.. interior the construction of hardware failure. choose the drives you % to lower back up and click next. very final internet site will show you the region the backup is being placed to boot as what you chosen for backup.. click initiate backup